DIY -3 Strand Leather Bracelet
October 23, 2013 8 Comments
One shank style button to be used as a clasp
Eighteen 4mm 6/0 metal beads or use Japanese 6/0 glass seedbeads for added color
Four gold-plated pewter distressed ovals
Two and a half feet (30″) 1.5mm leather cord
This three strand bracelet is made with one continuous length of leather. The leather is doubled through the oval beads to create a clasp and lattice pattern. Be sure to scroll down to the bottom of this posting for a chance to win one of two GIVEAWAYS!
Step 1: String one oval bead and the button clasp onto the leather.
Step 2: Feed the leather back through the oval bead to “trap” the button in place. Position the leather so that one side measures about 8 inches from the button. (The longer side of leather will be used to complete a loop and additional bracelet strand later on.)
Step 3: Onto the longer length of leather cord string the following beads: 2 6/0 seedbeads, 1 oval, 2 6/0 seedbeads, 1 oval, 2 6/0 seedbeads, 1 oval.
Step 4: Onto the shorter length of leather cord string the following beads: 2 6/0 seedbeads, string through the 2nd oval used on the longer leather strand, 4 6/0 seedbeads, string through the 4th oval used on the longer leather strand.
Step 5: Make a loop on the end of the second side of the bracelet by feeding the longer leather cord back through the last oval bead.
Step 6: Size the bracelet so that the overall length measures approximately 8 inches. Final sizing adjustments will be made after stringing the final row.
Step 7: String the following beads onto the final length of leather: 2 6/0 seedbeads, string through the 2nd oval bead of the middle strand, 4 6/0 seedbeads, string through the final oval bead shared with the other two strand of leather.
Step 8: Size the bracelet. Before crimping the leather in place it is important to properly size the bracelet. The loops at each end should measure approximately 3/4″ each. Adjust the strands until the length fits your wrist loosely. When each strand is the same length the bracelet should lie relatively flat.
Step 9: Using chain nose pliers, gently crimp down the oval beads at each end to secure the leather in place.
Step 10: Position each of the remaining oval beads approximately 2″ away from the closest ending oval bead. Using chain nose pliers, gently crimp down the two oval beads in the body of the bracelet. Crimping down these two beads will help keep the beads evenly distributed on the leather strands.
Step 11: Use wire cutters to remove the excess leather at each end.