How To Attach A Clasp With Crimp Beads


Tools Needed
Crimping pliers
Chain nose pliers
Flush cutter

Materials Needed
2 Crimp Beads
2 Crimp Bead Covers
1 Clasp
Soft Flex in a size that fits through the hole of the beads

We recommend the following to select your size:
Very Fine (.010″) – Precious stone or very small holed beads
Fine (.014″) – Semi-precious stone beads & pearls
Medium (.019″) – Glass beads
Heavy (.024″) – Heavy large-holed beads and metal.

Attach the First Side of The Clasp

Step 1: Cut a piece of Soft Flex wire 3 inches longer than the desired finished length.
Step 2: String on a crimp bead followed by one side of the clasp.
Step 3: Feed the Soft Flex wire back through the crimp bead trapping the clasp on the resulting loop.
Step 4: Push the crimp bead close to the clasp, keeping enough room for the clasp to move freely. (The loop of Soft Flex might be about as big as the crimp.)

claspcrimp1      claspcrimp2

Take a closer look at the jaws of the crimping pliers. There are two crimping stations. The inner one has a dimple in the center, this dents the crimp bead and is used first. The second section is oval shaped and is used to fold the crimp bead over itself, this section is used second.


Step 5: Insert the crimp into the inner section and squeeze the tool until the crimp is dented inward.
Step 6: Turn the crimp on its edge (a quarter turn to the left or right) and crimp it again using the outer station of the pliers.
For added security, we recommend squeezing the crimp a final time with chain nose pliers.

crimp2     crimp2     crimp3

String on your beads!
If the holes in the beads allow you to tuck the tail of the Soft Flex under a few beads, do so. If not, cut the wire with the flush cutter as close as you can to the crimp.


Attach The Second Side of The Clasp

The second crimp is secured using the same techniques as the first crimp.

Step 1: String on a crimp bead followed by the second side of the clasp.
Step 2: Feed the Soft Flex wire back through the crimp bead trapping the clasp on the resulting loop.
Step 3: Pull the excess wire until the crimp is positioned between the final bead and the clasp with no excess wire showing except the loop that the clasp is attached to. Be careful at this step to allow for proper tension, although you don’t want excess wire to show, you also don’t want the wire to be too tight.
Step 4: Crimp the crimp bead using the crimping pliers and chain nose pliers to secure it in place.
Step 5: Trim excess Soft Flex wire close to the crimp or bead.

2ndend    crimptrim

Add A Crimp Bead Cover
Crimp bead covers are optional but provide a professional finish.
Step 1: Place a crimp bead cover around the crimp bead
Step 2: Gently squeeze the crimp bead cover closed with chain nose pliers until it forms into a rounded ball.

pliercrimpcover     braccrimpcover2     braccrimpcover

Wear, gift, & repeat!

%d bloggers like this: